I bought a used Trotec Speedy 300 and to my surprise, there was no base. I did get the casters though. Being that the machine is almost 350 lbs, and only about two feet tall, it's too low to use on the floor with no stand. And it's too tall to put on a work bench.
I can buy one direct from Trotec but, believe it or not, it's close to $1000. when tax and shipping are added in. (Assuming tech support gave me the correct prices).
If I have to get a fabricator to weld up a base, I would need dimensions.
Are there threaded holes in the bottom of the laser which the stand would bolt into?
I can't lift the machine to find and measure these holes until I get two or three more people to help. I wouldn't necessarily have to bolt it to the base if it had a large enough platform to sit on.
Any Speedy 300 owners willing to send me measurements or post them here?
It would be greatly appreciated!