-
I got the sled's fence to .02 over 88 inches. I purchased a new framers square after checking against others on a flat surface. It got me a lot closer than my original square. The sled is only 24x30 so it will probably only be used to cut 10-12 inch boards so I should be pretty close I'm thinking.
-
I've trued my framing squares with ball peen hammers and it works. Be careful though if you have to hit too close to an edge that you don't generate a hump. If so, file it down. I also trued my Johnson 8" square inside and out. I made sure the inside and outside of the blade and the tongue were parallel with careful draw filing, then I trued them to 90 degrees and rechecked the parallels. If you file anywhere for adjusting the angles, you don't want to file any more than you can accurately cut, say 1/64". More than that you need the ball peen and center punch and start over.
Check them regularly, and square them again when (not if) necessary.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules