I have an embarrassing problem. I am making a table with 5 side-by-side drawers separated by dividers. Unfortunately, two of the openings are not square (I measured the divider height improperly, which has resulted in a 1/8" taper in the leftmost and rightmost openings.)
I have been able to plane the tops and bottoms accordingly to get the drawer to fit, but the drawer front is now slightly skewed relative to the opening. What is the best way to joint the top and bottom of the front drawer face to fit?
I don't want to risk blow out on the dovetailed sides by planing across the tops. Should I roundover those edges first?
Should i use a shooting board?