Hi All,
I am not sure whether to put this in the Chinese laser section, the Corel Draw section or here?
I am having an issue with size discrepancy when taking a bitmap image from Corel Draw, via dxf to Lasercut 5.3.
If I export the file as a dxf and import it into Lasercut, the file comes out at less than half the correct size in Lasercut. If I take the same dxf and open it in other programs, the image is the correct size
Does anyone have any advice? I have looked at settings in Lasercut but have not yet seen anything that may help. The same units of measurement are being used in both programs (millimetres).
Thanks and Kind regards, John