So I always have great ideas in my head, unfortunately those ideas don't always translate into an easy way to construct things.
I was looking to construct the dividers like the attached picture so that they are fixed to the sides. But now I'm concerned about being able to line up all of these pieces so that they fit nicely and don't have any gaps. I could see this method as being ok if I'm doing 3 or 4 pieces, but I'm doing 11, so the margin for error is there at several different places.
My alternate idea is to do the dividers the same way, but not notch them into the sides. If I do this though I won't have a good way to attach the dividers in to the tray. The bottom will a piece of plywood lined with a piece of velvet, so I can't glue it down to that.
Any advice or suggestions? Am I stressing out too much lining everything up? Is there an easier way to do it?
Thanks
Derektray.jpg