Hi,

I've just received an order about engraving small blank six sided dice (12mm) in large quantities (maybe 10000).

I know how to do it for a handful dices but i never tackled a huge order like that.

My normal steps would be :
- Place all the dice on face 1 in the laser
- Mask
- Engrave
- Paint
- Remove the mask and clean
- Turn all the dice on face 2 and realign
- Repeat

Obviously, the main problem is turning 10000 dices by hand, one by one !!!!

Even if i proceed by batches, the problem is the same.

I'm seeking for any solution from manual work tips to a full mechanical solution to build (!!!) !

Did someone had to solve this type of challenge before ?

Regards,

Philippe