I acquired a Davis and Wells 20" bandsaw and decided to put a new motor on it... 3-phase.

Found a really reasonable deal on 1 875 RPM 3phase motor, but only runs 480V - not dual voltage.

I've got two other tools in my shop (Poitras 4800 and Oliver 270D) that I've used the Huanyang VFDs to power.
Cheapo but they have worked for me.

However, the Huanyang units do not support 480V as near as I can find. Also, many of them do not support external braking resistors.

So, I found a reasonably priced used unit off ebay - GE AF60-LP.

On initial hookup and run and seems to work pretty well, but it doesn't seem like many people use them (based on forum surfing).
Anyone out there using these or had a bad experience? Mine has been fine so far.

-Bob