My 735 is not feeding. I've cleaned the rollers two or three times with mineral spirits. I've waxed and polished the plate twice. I've pulled the side box off and checked the drive chain - no broken sprockets and everything looks OK...both rollers are turning. I've rotated the knives so the new side is exposed (the old ones weren't so old, but I did it anyway). It's in a heated basement with essentially constant temperature year round. Today it's about 65º.
I take off 1/64" to 1/32" at a time. Just putting a 6" cherry board stopped it completely. I had to turn the crank up to get the board out of the planer.
I think I've exhausted all the suggestions from other posts. Is there something I've missed? Any help would be greatly appreciated.
Thanks in advance.