And one of the boards was a 2x4! Ripped that into four leg blanks, then turned them on a lathe. Breadboard edge on the top. Just a single drawer, though. White knob was just what was in the shop. May get a better one later. A look at what this high priced lumber made?
IMAG0056.jpgIMAG0058.jpgIMAG0059.jpgIMAG0061.jpg
Top is: 3/4" x 16" x 27". Table stands at 31" overall. Drawer bottom has a 1/2" thick plywood panel. Sides and front have a 1/4" wide by 3/8" deep groove, so the plywood panel has rebates on those three ends. Bottom of the panel is flush with the bottom of the drawer. Witch's Brew for the first coat, straight BLO for the final coat.
Couple hours at a time in the Dungeon Shop, about all I could handle nowadays.