Converting 20inch woodtek disk sander. HELP

[Chris worley]

Bought a 20inch disk sander it can be worked for either 110 or 220 is currently set up for 220. I need it to be 110 and I'm no good at electrical will post pics of diagram that's on the cover and the wires. Any help would be greatly appreciated. Looking forward to being able to get a tighter joint on my segmented bowls and hollow forms. Screenshot_2015-03-20-13-00-02.jpgScreenshot_2015-03-20-13-00-10.jpg

[Carl Weber]

Chris, for a CCW rotation use the wiring on the far left CCW.JPG The wires should be marked. For a CW rotation use the wiring next to it. CW.JPG. Connect your incoming 120v wires one each to the red number and connect your ground. You should then be in business.

[Chris worley]

Ok I forgot to mention that it has a forward and reverse switch didn't know that mattered till I mentioned it on another post. And I also found the numbers that are on each wire since I posted the first time.

[Chris worley]

Here is another pic don't know if will help any more PicsArt_1427031931751.jpg