Hello Group
I finally think my learning curve is getting shorter. Now it is the fine tuning between graphic design, software, and setup. I wonder if there is a formula or a 'typical' trick to getting this kind of engraving right over and over, as in multiple pen job. The picture is my first pen success. I do not have a jig, or know how to make one, and I have what is called a 'simple' rotary device.
I appreciate any feedback on how to set up to get a successful multiple pen job.
CelticKnot.Engraved.Pen.b.jpgSimple.rotator.jpg The picture is not mine, the basic design is the same.
So now, if you were going to make 4 pens how would you set this project up to get a consistent and successful run?
As always, Thank You for your generous help
Roy