I tried to find a post on this, figuring it would likely exist but didn't have any luck. I am taking on more and more projects laser etching glass, and am having issues with the glass burrs that are left behind. Typically right now I spray the glass down with Windex or something similar and then wet sand with a 12,000 grit sandpaper or pad. It works ok, but doesn't seem like a viable option for a large group of items.
1. Does anyone have any other suggestions to smooth out the burrs (on about 500 round 3" disks).
2. Does anyone know where I can purchase 12,000 grit paper/pads in bulk (currently paying around $5 for a 2"x2" pad)
Any help or guidance is greatly appreciated and I apologize if there was an existing post on the topic.
Regards,
Mike