Hi A331 owners,
I need your guidance here.
I recently run many >5 feet boards through A331 and noticed that the surface and edge are convex.
In the Hammer term, it is "open joint".
The manual says I need to turn an eccentric after loosening a small screw, but the eccentric is so tight and it won't move at all.
I wonder if somebody can share your experience about how I can possibly move this thing, which way I should turn to lower the outfeed, and how this eccentric can move the table. It doesn't make sense that the heavy table is held only by the small screw to me....
Thanks,
Susumu