I have an Epilog Zing 24 40w in my classroom. I have been etching yeti tumblers and the like using the rotary attachment for our robotics fundraiser. I would put the artwork in the center of the page in Corel Draw and set the print dialog up for center center engraving like normal. I would position the laser pointer in the center of where I would like the artwork and set that as home. It would then work as normal, rotating counter clockwise to the beginning of the artwork and start etching.
I come in about a week ago and now it doesn't work. I set it up as I would before, but now it rotates clockwise beyond my center and then start etching. I saved the artwork as a PDF to see if it was something in Corel, but the same deal.
Is there a setting that I may have hit in the dialog or something on the laser.