20160526_145916_resized.jpg

From a 2"x2" to round. I found myself having an easier time with using a skew rather than the roughing gouge. I tried cuts with the parting tool which went pretty well and a beading gouge which was much harder but a couple of decent beads. I then tried to grind the skew and messed it up. I will need to contact D-Way tools and find correct angle. I tried using a Stuart Batty Angle Gauge One but must be doing something wrong. I thought I saw on one of his videos that Dave ground them to 60 degrees, but when I set the platform according to the directions that angle was no where close.