Hi all,
I am trying to think through the challenges of executing a coffee table with waterfall edges on the ends (top slab has continuous miter at both ends so that slab flows all the way to the floor). The table needs to be 24-28" wide and I see no way to execute the miter on my cabinet saw even if I use a crosscut sled. I am assuming that the slab thickness would be 1-1/4 to 1-1/2" thickness.
The second question is best means to fix the miter joints. I don't have a Domino. The only way I can think of to add needed strength would be a cleat on the underside screwed to both sides of the joint.
Please share thoughts. I sure don't want to get into the middle of this and find my approach was not sound.
Thanks, Steve