A recently acquired Millers Falls #214 saw set (or clone) is outmaneuvering me. I want to remove the anvil and grind on it, as the tip of the anvil is chipped off. The handle is mounted with a drift pin, which was no problem to remove. Removing the handle allows access to the barrel of the tool, in which resides the anvil. The anvil is spring loaded, and tension on the spring is maintained with another drift pin, which goes through the barrel. This is embedded in the body of the tool. It looks to me that the drift pin has to come out to release everything. There's not enough room to tap out the drift pin, I don't think...but somebody got it in there, it's gotta come apart, seems to me. Has anyone dismantled one of these saw sets?