I've searched everywhere and can't find this addressed. Maybe I'm just not understanding the manual but in setting up my Incra 1000HD miter I'm being stumped by the process of zeroing the fence scales. The manual goes through a process to zero the fence scale for 90 degree work. The problem is that if I do that and follow the instructions in the manual, it sets the aluminum fence too close to the blade to allow clearance for angled cuts. Am I missing something or is there a way to zero it so that it clears the blade at all angles? If not, I'm guessing you have to use the shop stop to reset your zero mark each time you go back to 90 degrees and then move the aluminum each time you want to cut at an angle. I'm hoping there is an easier solution though. Thanks.