https://www.youtube.com/watch?v=eYz1idJxssw
Interesting little gadget, but between the climb cut in the video and the requirement to have my fingers that close to the spinning bit. I think I'll pass.
[OP]
Member
https://www.youtube.com/watch?v=eYz1idJxssw
Interesting little gadget, but between the climb cut in the video and the requirement to have my fingers that close to the spinning bit. I think I'll pass.
Interesting tool. You could easily make a guard to keep fingers from the bit. With the work clamped down and a two handed grip on a router taking a very thin cut, I see no problem with the climb cutting. Climb cutting would eliminate any tear out from that finish cut.
Lee Schierer
USNA '71
Go Navy!
My advice, comments and suggestions are free, but it costs money to run the site. If you found something of value here please give a little something back by becoming a contributor! Please Contribute
Member
Looks like it'd take a fair amount of practice to get consistent results with that attachment.
Interesting idea anyway.
Posting Permissions
Reply With Quote