Table Saw Trunnion Lube

[Yonak Hawkins]

I don't tilt my table saw blade often and, whenever I do, it is nearly seized. I have been using spray graphite on the trunnions. I know, I know, I should work it more and lubricate more but, what kind of lube do other folks use ? Is there one that lasts longer than others ? Thanks.

[Mel Fulks]

I use the "never seize " stuff. Once or twice a year is enough. Even with saws that get filled with sawdust the mechanism works smoothly right after the dig out.

[Myk Rian]

Canning wax.

[Rod Sheridan]

Dry Moly lube in an aerosol can................Rod.

[Martin Wasner]

Grease on the slidey parts, including the worm gears. Oil on the spinny parts like shafts. I have to do it maybe every eight months in a full time cabinet shop

[Yonak Hawkins]

Martin, don't you have a problem with it getting gunky and dried out from sawdust ?

[Osvaldo Cristo]

I don't tilt my table saw blade often and, whenever I do, it is nearly seized. I have been using spray graphite on the trunnions. I know, I know, I should work it more and lubricate more but, what kind of lube do other folks use ? Is there one that lasts longer than others ? Thanks.

I use a small amount of lithium grease. It has worked for me in the last 25+ years with the (same) tablesaw...

[Martin Wasner]

Martin, don't you have a problem with it getting gunky and dried out from sawdust ?

Nope. It gets a cake of dust on it, which eventually falls off, but it doesn't hurt anything. It probably actually forms a seal of sorts with dust caked on it.

It doesn't take much to lubricate a low stress moving part that doesn't move much.

[Charles Lent]

I use Johnsons Paste Wax applied with an old tooth brush for several reasons. It's relatively easy to apply, stays in place well, the surface crusts and dries making it less likely for saw dust to stick to it, and it never never stains the wood if it should ever come into contact with it. In fact, I also apply several coats of this wax to the table top to lessen the chances of rusting and to make the wood slide easily over it. I have never had a problem with it affecting the finishing of any of my work either. A kind of multi purpose solution for table saws and other cast iron tools, but also handy for granite and aluminum surfaces. My Unisaw gets re-lubricated every few months. The top gets re-coated whenever the wood doesn't seem to slide easily over it or if I won't be using my tools for extended periods.

Charley

[Rick Moyer]

I use a small amount of lithium grease. It has worked for me in the last 25+ years with the (same) tablesaw...

Me too. only seven years on same saw though.

[Ole Anderson]

Reminds me I probably ought to lube mine for the first time in 15 years...

[Osvaldo Cristo]

reminds me i probably ought to lube mine for the first time in 15 years...

lol :d:d

[Van Huskey]

Reminds me I probably ought to lube mine for the first time in 15 years...

My first thought was "they need lube"? I have occasionally cleaned mine but don't think I ever lubed them on any saw I have had.

[Roger Green]

My dad (old school industrial arts teacher) all ways made a crayon by melting paraffin (canning wax) and stir in a tube of dry graphite powder. When it has cooled down, form it into a large crayon. Wrap masking tape around 2/3 of it (the graphite is a little messy to handle). Now you have a dry lube that will not attract dust.
Roger Green

[Doug Ladendorf]

I like Dri-Slide, a dry moly/graphite spray that dries.