This lathe is a behemoth. It arrived in perfect condition the crate didn't have a scratch on it and everything was packed impeccably. I managed to get it set up within an hour with ease. It has a lot of metal and everything feels solid. I have no doubt it's going to be a great lathe if I could get it started. After I got the power run to it I went to turn it on and I could hear the inverter come on in the back but then it shut off after the RPM display blinked all zeros. I did a basic check to make sure there were no loose wires or anything that I could see that was immediately wrong. If I press the green power button in it keeps doing the same thing. Does anyone have any suggestions or has anyone faced this problem before? I'm sure Grizzly will be able to resolve the problem on Monday but I'm dying to get this thing running.