This was my 1st time playing with engraving plastics. It's Gemini Duets Laser XT. After many tries, I figured out how to get a good engraving. But I'm running into a few problems and I'm hoping I could get some help.
1st problem
When I go to cut the plate out the edges discolor just alittle bit. How do I prevent this? It's something I notice but the customer might not.
I've tried with lots of air assist and with only alittle bit. I've tried fast/high power as while as slow/low power. All of these seems to produce the same effect.
2nd problem
My customer wants it in a hunter green and white with an adhesive backing. The picture shows Duet L-111-106 and I can't seem to find any sheets with adhesive backing from JDS. Is this something I have to put on or does anyone know of a similar product that already has adhesive backing?
Thanks for any help!
IMG_4549 (Medium).JPGIMG_4550 (Medium).jpg