[OP]
Member
Hi guys.. I'm new to the engraving world but what I have found is that when i scan an image to the yeti cup it comes out with streaks throughout the whole scan any insight on this? What can I be doing wrong?
I guess what I am trying to say is that it doesn't completely erase all the image like on the preview. Speed is 100 power 65
Last edited by DANNY RIOS; 02-23-2017 at 3:17 PM.
If consistent, then what do you have the scan gap set on? I use 0.08 for most work. Small the number, the closer the lines.
Woodworking, Old Tools and Shooting
Ray Fine RF-1390 Laser Ray Fine 20watt Fiber Laser
SFX 50 Watt Fiber Laser
PM2000, Delta BS, Delta sander, Powermatic 50 jointer,
Powermatic 100-12 planer, Rockwell 15-126 radial drill press
Rockwell 46-450 lathe, and 2 Walker Turner RA1100 radial saws
Jet JWS18, bandsaw Carbide Create CNC, RIA 22TCM 1911s and others
Contributor
First are you using a standard CO2 laser or a Fiber machine? Cermark or not? Did you set it up and try on a inexpensive whatever instead of a $30 Yeti cup and how were those results? I don't understand Erase like preview?
What machine, what brand, power?
Lots of variables before anyone can give you an intelligent answer. The Search command on here will save everyone a Lot of time.
Retired Guy- Central Iowa.HVAC/R , Cloudray Galvo Fiber , -Windows 10
[OP]
Member
I will try that thank you for your reply
Posting Permissions
Reply With Quote