Results 1 to 3 of 3

Thread: Homemade overhead table saw dust nozzle

  1. 10-04-2017, 9:49 PM #1
    Joey Stephenson
    Joey Stephenson is offline [OP] Member
    Join Date
    Sep 2017
    Location
    North GA
    Posts
    36

    Homemade overhead table saw dust nozzle

    Got some 2 inch PVC pipe and cut up some leftover styrene I had from an R/C truck project to make a custom nozzle/gaurd. Glued the pieces together with Plastruct Plastic Weld. Its connected to a weak little shop vac right now, but it pulls enough to keep the tiny dust at bay, and helps block some chip spray.
    Attached Images Attached Images
    Last edited by Joey Stephenson; 10-04-2017 at 9:56 PM. Reason: This forum has serious bugs for text entry
    Reply With Quote Reply With Quote
  3. 10-04-2017, 10:41 PM #2
    Brice Rogers
    Brice Rogers is offline Contributor
    Join Date
    Sep 2015
    Location
    San Diego, Ca
    Posts
    1,648
    Looks like it will be effective. How much sawdust comes off the bottom side of the saw?
    Reply With Quote Reply With Quote
  4. 10-05-2017, 12:20 AM #3
    Joey Stephenson
    Joey Stephenson is offline [OP] Member
    Join Date
    Sep 2017
    Location
    North GA
    Posts
    36
    Quote Originally Posted by Brice Rogers View Post
    Looks like it will be effective. How much sawdust comes off the bottom side of the saw?
    As much as you would expect! I don't have a dust collection unit right now, so it just piles up underneath at the moment. Not a problem, currently. I'll eventually get a 1hp shop fox or something. The WEN ceiling mounted 1 micron air cleaner helps to keep the air clean in the mean time.
    Last edited by Keith Outten; 10-12-2017 at 1:39 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules