It’s been a while since I posted, some small projects here and there, but knee surgery was the better part of my year last year!
Anyways, getting into door making next, I got an opportunity to build some doors, and wanted to take advantage of this to practice and get some run time on making doors. I’m not making any money off of it, but I am getting the wood and router bit set paid for!
I remember a poster a while ago setup a fixture to glue up wood to keep it flat. Assuming that ¾” was used to get to 1 ½”, hence the fixture, or is it advisable to go straight to 6/4 and mill down from there?
Can anyone also recommend which bit set they used? The Freud’s seem to come with great directions and cheat sheets, but some of the reviews are throwing me off.
Infinity seems to have a good set, but out of stock, due in April….
Any advice is appreciated…any good reads out there on this subject?
THX