I've always struggled with this end snipe, and I can't really figure it out. I have a new 15" Grizzly planer, just tuned it up, outfeed, infeed and chip breaker heights and I'm still getting it pretty bad.
these are 20' timbers, and we're keeping them pretty level especially as it's about to exit, but I'm getting these bad snipes 3" from end of board and a light stink deep! It's right as it exits the infeed roller, seems to pause, then get picked up by the outfeed. Might be getting slightly hung up under the chip breaker. I have the bed rollers almost flush with the table. These snipes are the same ~1/16 depth all across the 3" part.
lot's of work planing these timbers, I want to do a nice job! What could I re adjust tomorrow? I'm thinking the outfeed could come down a bit, or the infeed, up?