I have decided to plumb my air lines with 3/4" copper pipe.
I did research old threads and made my decision on what I feel will work for my skill set and overall usage off the system.
I am saying this since I am trying to avoid a discussion of PVC v whatever.
The system I plan to install would be 3/4" around the shop, with 1/2" drops plumbed from the top of the 3/4" pipe.
I will add an automatic drain at the end of the 3/4" run to discharge any water build up, also add one to the bottom of the tank.
My sticking point is what copper fitting do I use to connect 1/2" drop to a quick disconnect that states it has 1/4" (F)NPT
The few fittings the BORG has would not fit onto the QD.
Anyone with a copper system, can you share what fittings you used?
Thanks