I have a zing 24 and it just stopped firing and I can't figure out why. I talked to Epilog support and they sent me 4 new interlock sensors, which I installed and still have the same problem.
I have checked all the obvious things like vector cutting, outline set to hairline, doors are all closed, the head moves but no laser cutting. I have tried running files that worked the day before. nothing.
The lights on the side show the interlocks are working, and the laser ctrl is working, but the LED for the laser does not illuminate (because it isn't firing!)
Any suggestions of what I should try next? My machine is less than 2 years old and I don't use it that often.
I have checked all the exhaust vents, the filter on the air assist, and I have rebooted, unplugged, and every other general reset I know of.
Thanks for any ideas!
-Trisha