Here is a corner cabinet I just finished. I designed it to match a sofa table/cabinet that has a quarter round drawer on both ends.
The construction is shop sawn walnut veneer vacuum bagged onto Baltic birch plywood for the visible flat panels. The bent laminations were done from more shop sawn veneer and plastic resin glue, in the vacuum bag. The finish took a long time to figure out to get a good match to the existing piece. I made over 30 specimens before being comfortable I had it right. The general process was dye, sealer, dye/stain, sealer, toner, finish coats. But I think you'll agree the effort was worth it.
The drawer rides on a single KV center undermount slide.
Here is the cabinet with the drawer I had from the existing piece for matching.
John