Can someone let me know what environments you are using your TroTect or Epilog Laser Engraver in.
What is the room temperature (on average) and can anyone tell me how humidity effects the Laser engraver?
Our Makers Space is an air conditioned portable building. Temperature thermostat set at 70 degrees but it can have times that the room gets hot when the AC goes out.
As far as during the winter. The room is heat controlled as well, since it is a portable building the walls and insulation are thin which does allow us to easily vent exhaust and fumes to the outside using a blower or fan.
Is there any difference between an Epilog machine and TroTec on their prefer working environment and what would happen to the machine if the AC is out for 5 days and the room reaches 85 degrees?
Any problems if the heat fails and the room gets cold (down to 40 degrees) in the winter.
These would be rare events but I want to make sure I understand the optimal working environment for these machines and also if someone is doing Laser Engraving in a setting similar to ours what challenges does it present (if any).