I've recently taken up woodworking and would like to purchase my first table saw. I want to use it to build furniture (kitchen table and a few coffee tables to start). I can't see myself needing to cut anything thicker than 8/4. I've done a ton of research but I can't seem to make up my mind. I have narrowed it down to three choices (all prices in CAD as i'm in Canada):
- Rigid R4512 / Delta 36-725 contractor saw for ~$800. If I get a good saw (no alignment or other issues) this should work out well but I worry about getting a lemon. I'm also worried that this might not have enough jam to cut 6/4 or 8/4 hardwood -- I've read that it's ok but that you just have to take it slow.
- Pick up an old Unisaw. This is nice in that I get a very powerful saw with a bullet proof design. I'm not a huge fan of the lack of safety features (riving knife) and the lack of a warranty. I've found a few but all of them needed varying degrees of work (fence, alignment, rust, belts, arbor, bearings). I could probably get into one for ~$1000 but that would definitely require some TLC. As an aside to this option - I found a guy locally who purchased a bunch of old unisaws from a trade school. The machines have 3 phase motors and need to be outfitted with a VFD in order to work with 220 1p. For $1650 he will provide a new blade, table insert, arbor nut and compression washer, sandblast w/ new paint, polished top, sawstop 36" t-glide fence system, lenze VFD and delivery w/ setup. I've seen some pictures of his work and it looks solid but $1650 is pretty steep for a used saw.
- General International 50-270KDL M1 -- this is on clearance at a local shop -- $2100 (floor model, assembled a few weeks ago but never run).
I guess I'm just looking for some advice. As someone that is just starting out, the choices are a little daunting.
Any help would be greatly appreciated.