I had someone ask me to do a waveform for them. They supplied the wood, stained it and most importantly the waveform.


I believe the wood is Alder, it measures 31" x 10.5" x.75", He used an Ebony stain which turned out pretty good. I was afraid it would soak into the wood and might not let the vcarve have a crisp contrast but it wasn't an issue.

Bits used
.25 3 flute end mill
.0625 2 flute end mill
30 degree v- bit
60 degree v bit

Turned out pretty good, although I did have some issue with the flatness of the board

I used V-carve Pro for the CAM/CAN