here's an oldie for bandsaw fans:
1002.JPG
i picked up this 1915 crescent 20 a couple of years ago, here are a few pics of the restoration
first the pic on kijiji
$_35.jpg
it was powered by a tiny 1/4 hp motor hanging on a 1 inch bolt through the frame. the po was using iot to cut brass and aluminum, he was a hobby machinist
they didnt care too much about esthetic in 1915, lots of filing and filling before new paint
042.JPG
i made new guides so that i could increase the resaw
002.JPG
there was no lower guide, so added a similar one
the saw is now powered by a 1940's 1hp delta repulse induction motor and added the guards. interestingly, the saw does not use tyres, there is a step machined on the rim for tooth clearance