Hi,
Let me start by saying how much I have enjoyed this forum.
I am about to enter the world of turning and I realize how much I have to learn. This forum has provide hours of learning and enjoyment.
I am about to address my sharpening needs, at the moment I am considering the following 3 options:
1. construct my own sharpening jig
2. purchase the wolverine jig
3. purchase the kelton jig
My specific question regards the comparison between the Wolverine and
Kelton jig. I have read many favorable write-ups regarding the Wolverine set-up, however where the Kelton seems to be a fairly new entry into this market, I have not been able to find many 1st hand accounts regarding the use of this jig.
Is anyone familar with the Kelton jig ? If so, I would appreciate any feedback you may provide. Also, any feedback regarding the Wolverine and constructing one's own jig would also be appreciated
thanks,
Howie