I just saw an article titled "Getting the most out of your planer" one of the tips was making a jig to hold boards at 90 degrees in order to plane edges. I have run small boards through on edge maybe a handful of times but it is not something I generally do. My usual routine is from rough cut; plane to thickness, run straightest side through jointer and then rip width on table saw after that I may joint pieces on the router table if necessary. How many of you run cut pieces through the planer on edge as part of your normal routine? Do you find that it is easier to get consistent dimensions by doing this as opposed to using just the table saw even with the possibility of chip out, chatter etc. ?