Ugh. I'm such a klutz.

[Gary Herrmann]

Cutting some baltic birch to make a ts jig, and I managed to knock my Woodhave miter gauge off a nearby table. The head unit is square, but the bar has bent and twisted a bit. I may still try to bend it back, but I wonder if they sell replacement bars? 'Course they're not open today. This may be a good reason to watch college football this afternoon and drink beer.

Argh

[Brad Olson]

I have the problem of laying stuff on any available surface, and almost killed my incra miter guage a few times.

So I went to home depot and bought some of those over-the top of the door hooks and attached two of them to the side of my table saw. I used these hooks because the diameter of the hook is large enough to hold my miter guage. Now when I am done with the guage I just hang it on the side of the table saw, no worry of bumping it off the table.