Ok, now?
IMG_2020 (640x480).jpg
Had to get out a "new" candle, wore the old out. After each groove was ploughed, decided to try something...different.
IMG_2021 (640x480).jpg
I ran the 60-1/2 along, to do a slight bevel, on both corners of the groove, Seems to help the raised panel sit in the groove better..
IMG_2022 (640x480).jpg
Got four rails done, now the fun part..
IMG_2023 (640x480).jpg
Had to make sure the outside part of the jig cleared the bottom of the fence on the Stanley #45, yet still helped to hold the stile in place. Marks from that screw will not be seen. Then a few swipes with the block plane, again. Finally got all 8 parts grooved
IMG_2025 (640x480).jpg
Was I done for the day? Nope, decided to try some tenons..
IMG_2026 (640x480).jpg
Laid out for a tenon, Mitre saw to cut the shoulder cuts..
IMG_2027 (640x480).jpg
Bandsaw to make the cheek cuts.....
IMG_2028 (640x480).jpg
Reset the mortise jig....and then called it an afternoon....lunchtime! Might meander back to the shop, later....and chop a few mortises...would like to get at least one end panel glued up
May have to work on a Monday, otherwise......stay tuned