Hi,

Am at a point, where I need to sharpen this little bitty #11 Pfeil straight palm gouge.

The sides are about 1.5mm high-tiny, right?

The side was chipped out--so the moment I have put off forever is here-no more stropping/honing-the edge must be ground back straight (done), and then sharpened.

My question is.....since am using these small oilstones....I can't figure out whether the soft or harder would be the coarse or fine one.

The soft one would be equivalent of more coarse, right?

And-as far as creating another viable edge, make the tip flat, then treat like two separate chisels, right?




004.JPG


Thanks