Results 1 to 3 of 3

Thread: Maple scraps and a few metal parts?

  1. #1
    Join Date
    Jun 2010
    Location
    twomiles from the "peak of Ohio
    Posts
    5,275

    Maple scraps and a few metal parts?

    Old Butcher's Meat saws.....seen almost in every garage sale/antique shop.....
    IMG_2442 (640x480).jpg
    Had a few too many of these, just hanging around. had some leftover 1 x 4 Hard Maple...hmmm
    IMG_2433 (640x480).jpg
    I did have to go out and buy a 2' length of 5/16" all-thread, a wing nut, and a washer...
    IMG_2435 (640x480).jpgIMG_2434 (640x480).jpg
    But these parts here came from the Butcher saws. Blade is 18" long, with 11 ppi crosscut teeth.
    crosscut.jpg
    Works great as a crosscut saw....with no tearout on the backside of the cut..
    backside.jpg
    There is only one wingnut to tighten the saw with..
    wingnut.jpg
    The other end of the all-thread is folded into a mortise, to keep from twisting..
    folded end.jpg

    About maybe $5 in parts....couple of hours "play time" in the shop, while watching the washer....

  2. #2
    Join Date
    Apr 2010
    Location
    Berkshire County in Western Ma
    Posts
    55
    Nice little project. I picked one of those meat saws up at our local thrift shop for a buck. Can't believe no one else grabbed it.

  3. #3
    Join Date
    Nov 2006
    Location
    TX, NM or on the road
    Posts
    656
    I've made several of that type of saws over the years, there is something about cutting a piece of wood using one that makes the world slow down. But I never thought of using a meat saw, I used what ever blade I can scrounge and adapter the blade holders to fit the blade. A lot of them were fret type saws that I used coping saw blades on. A bolt with an angle cut and cut from the end with the bolt head removed made the blade holders.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •