Results 1 to 15 of 16

Thread: Powermatic 1200 drill press - replacing chuck?

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 11-30-2017, 9:57 PM #1
    Phillip Mitchell
    Phillip Mitchell is offline [OP] Member
    Join Date
    Dec 2015
    Location
    Boone, NC
    Posts
    1,400

    Powermatic 1200 drill press - replacing chuck?

    I'm wondering what my options are for replacing the chuck on a early 70's era Powermatic 1200 drill press. I'm a drill press newbie.

    The machine does not have a chuck installed. I'm curious about where to buy a chuck, what's the best option, cost, as well as ease of install.

    Also, the motor is 220V. Were these only 3 phase motors, or is there a chance it's single phase? Looks to be a variable speed model with the rectangular table with a "trough" all the way around the perimeter.

    Thanks for any help!
    Last edited by Bruce Page; 12-01-2017 at 12:02 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules