Sawstop Front Rail Fence Support - metal gauge/thickness

[Dale Murray]

This is a silly request but hoping somebody can help me out in a pinch.

I am designing a new extension/router table (not out-feed table) for my ICS and about to order hardware when I realized I dont know thickness the front L shaped rail - not the boxed beam - just the L shaped rail. I believe it is 1/4" but not sure.

I'm hoping to build over the holiday and trying to get all the parts ordered. I'd measure myself but I'm at work.

Thanks

[Peter Christensen]

I have the original SS (don't know what the designation is for it) and the angle iron that supports the box beam is 1/4" or 6mm. Kind of hard to tell with just a tape measure.

[Dale Murray]

Thanks.

That is close enough for me. I want to make sure the hardware I order will not extend beyond the t-nuts I intend to use.

[Roger Feeley]

I just measured my ICS.
1/4” nominal
actual varied from .249” to .253