My lathe setup is about 20 feet from my DC. I have a HF DC unit with a thien baffle system that has served me extremely well for all of my power tools, ie., TS, jointer, planer,BS, etc. I have been using 4" PVC as the main line with the drops approximately 6 feet or so at best to each machine. There are never more than one machine on at a time.
I have several questions.
First, will a 20' run be too far for this system? (This would be a straight line with no curves, but would be 4" flex hose).
Second, what type of setup do most use as far as fine dust is concerned? Personally, I can't see a DC unit doing much good with the chips flying off a lathe. Seems to me it would have to have a complete shroud surrounding it to be effective. That being said, sweeping up with a broom and or shop vac would seem more realistic.
I understand the importance of dust extraction for fine dust, especially when sanding, and I am sure the DC would handle that.
Just wondering before investing in more pipe or hose for this project.
Looking forward to some feedback.
Thanks, Steve.