I now have two taps. One is 2 1/4, the other is for 2 1/2. Unfortunately the thread angle is 60 degrees on both. I would like to find or have one made that is 90 degrees. If I have one made, should it be 2 inches in the middle with 1/2 inch teeth to get 2 1/2?

Anyways, I would like to make a couple of die boxes for these two. For these sizes I should have two cutters in the box right? I would like some help or advice here. I would really like pictures of boxes with two cutters.

I have not been on this forum much and I'm not sure how or if we can post pictures. Thank you.