Page 3 of 3 FirstFirst 123
Results 31 to 32 of 32

Thread: Round over cast iron?

  1. 10-25-2018, 9:47 PM #31
    Peter Quinn
    Peter Quinn is offline Member
    Join Date
    Feb 2008
    Location
    Northwestern Connecticut
    Posts
    7,149
    Quote Originally Posted by Larry Edgerton View Post
    Did it with an old 3/8" router bit in a few passes. Worked well. Thanks, y'all..........

    Make sparks?
    "A good miter set up is like yoga pants: it makes everyone's butts look good." Prashun Patel
    Reply With Quote Reply With Quote
  2. 10-26-2018, 3:34 PM #32
    Roger Feeley
    Roger Feeley is offline Contributor
    Join Date
    Oct 2007
    Location
    Falls Church, VA
    Posts
    2,345
    Blog Entries
    1
    Here's a thread on PracticalMachinist forum about routing cast iron. Loads of good information by people that have done it.

    https://www.practicalmachinist.com/v...router-276910/
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules