Just perusing the posts here on the benchtop bandsaws. Most bandsaw threads are that you need more saws, and bigger saws.
I have a larger LT18, and a smaller Jet 14". The Jet is nothing special but I use it a lot. However, as many of you can relate, I am pressed for space and my shop is getting more crowded than I would like.
So wondering if I went down to a benchtop machine (like the 10" Rikon or such). It would save some shop floor space (I have a bench spot I could put it on).
Have read the fence and miter isnt great. A consideration. And table size is smaller. Might miss the larger table. But most of my work on the smaller saw is.. smaller stuff. Odds and ends and curves and anything that I dont want to run through the resaw blade, which stays on the larger saw 95% of the time. Its not obvious to me power would be a problem unless grossly underpowered.
Anyone want to offer opinions? (opinions about bandsaws!)
(and my apologies if this has been covered ad nauseum... it may be here and I missed it)