First real post in the Turner's forum. Long time lurker, and I've mostly frequented the engraving section.
I'm planning on upgrading from a small HF lathe to a Laguna 18/36 by the end of the month, and I'm looking for some advice on my first chuck. There seems to be quite a few options out there, and it's somewhat confusing. I'm just looking for an all-around option right now. Currently I mostly make wands, but I hope to get into bowls/platters at some point.
Right now I'm leaning towards the Supernova2. There's an Anniversary kit with 2", 4", and 5" jaws. Prices seem to vary wildly. One site has the set listed for $169, but Rockler sells the same set for $308. This chuck fits the 1-1/4" 8TPI spindle on the 18/36. If I go with something like the G3, does that mean I buy the Nova Insert/Adapter, 1-1/4" 8-TPI?
Admittedly Nova is the brand I've researched the most, but do other brands work the same way?
Thanks in advance for any advice!