Hello, I recently upgraded to a Delta Unisaw Model 34-806, and am having some difficulties with getting it set up. Any and all suggestions are welcome. The problem is that I cannot get the saw to start with the start switch. I don't believe the motor is bad, because if I manually bridge the magnetic contactor, then it turns, and stays on (as long as I keep the contacts in place with my insulated screw driver). This has been the case before and after I have replaced the Magnetic Contactor Motor Starter #583-00-001-0066. In both cases I the mag coil hasn't seemed to turned on and engaged the contacts. I am fairly new to wood working, and even newer to electrical stuff, so if I have left out any pertinent information, or have ended up over looking anything obvious, then I greatly appreciate your patience and understanding. Below are any and all details I can think to list. Finally thank you to all who spend the time looking over this and offering their assistance. The Starter Diagram is attached, as well as the Phase a Matic Converter information.
I have found the instruction manual at: https://www.manualslib.com/manual/72...NISAW%2034-806
The Phase a Matic Instruction manual can be found here: https://phaseconverters.phase-a-matic.com/Asset/SIS.pdf
Saw: Delta Unisaw #34-806
Motor: 3 Phase, 5hp, 230v Motor #87-369
Phase Converter: Phase a Matic #PAM-900
Mag Contactor: #583-00-001-0066