Has anyone opened up the motor / impeller housing on a Delta 50-760 DC? Possibly to replace the motor or the impeller? I'm not looking to do either of those, but I am thinking of rotating the switch location by 90 degrees.
As it stands right now, the switch faces to the "right" in my setup, as shown below. I would like to rotate this position clockwise so that the switch faces "front" as much as possible. That will make it easier for me to reach the switch from either the left or right side of the unit.
50-760.jpg
It should be just a matter of removing those bolts, turning the whole assembly clockwise, and tightening those bolts back up. But I'm pretty sure there's a gasket under that flange there, and I don't know if that will get ruined when I lift up the assembly. I was hoping somebody on here has at least opened this up before me and could provide some info.
Thanks,
Steve