Originally Posted by
Chuck Kahler
can someone recommend a good way of splicing these high-voltage wires without using the ceramic connector?
I can't tell you if it is "good way" but this is what I did, and it has not given me any problems.
I stripped about half inch of insulation from each side and soldered it together in a lap joint.
Then I wrapped electrical tape around the bare wire until it was the same thickness as the insulation.
Then I wrapped a LOT of electrical tape around the joint about covering about 6" (three inches each way) until it was about 10mm thick.
Then I covered it with a length of silicone tubing.
Shenhui 1440x850, 130 Watt Reci Z6
Gerber Sabre 408