Good morning! I just upgraded my Universal 50 watt to a Trotec Speedy 360, 80 watt. When I send my engraving file over to JC from CorelDraw, it seems that JC adds a desert blue vector around my artwork. I wouldn't care except when I try to cut out something with the red cut line, it also cuts on the desert blue vector. The line is not in my Corel file and I can't figure out how to remove it in JC. Ideally, I would like it to not even appear but I can't figure out how to do that. Any insight is greatly appreciated!! Thanks, Guys (and Gals!)
Jerry